G1, G2 & G3 GRINDERS
USE & CARE INSTRUCTIONS
STEP 1 STEP 2 STEP 3 STEP 4
Raise the top lid and add the whole
bean coffee. Close the top lid.
Allow the bag to rest on the screen
beneath the chute.
Turn the selector knob to align the
red arrow with the desired grind.
STEP 5
Turn the ON/OFF switch to ON and
press the start switch.
STEP 6 STEP 7
STEP 8
39565.0000A 10/06 ©2006 Bunn-O-Matic Corporation
39565 102506
Locate the back of a bag behind
the dispense chute. (The grinder
will not operate unless the bag is
behind the chute.) This will activate
the bag switch.
Flip the cleaning lever a few times
as dispensing slows.
Remove the bag when ground cof-
fee is no longer dispensed from
the chute. The grinder will stop
automatically when the bag is
removed.
NOTE - The start switch will have
to be pressed again to continue the
cycle if the bag is removed before
grinding is completed. Turn the
ON/OFF/START switch to the OFF
position.
COFFEE GRINDING
STEP 2
STEP 3
WARNING - Prior to cleaning the
grind chamber, unplug the grinder
before removal of any panel or grind
chamber housing parts.
Empty all beans from hopper(s).
Plug in the grinder and place an
empty bag behind the dispense
chute. Press and release the
“START” switch. Run a few cycles
until all coffee in the grind chamber
is dispensed and disconnect the
grinder from the power source.
Remove the bag.
STEP 1
Clean all exterior surfaces using
a damp cloth rinsed in any mild,
nonabrasive, liquid detergent. Care
should be taken not to scratch the
grinder with any abrasive material.
STEP 5
Remove the two screws securing
the stationary burr to the grind
chamber.
STEP 4
STEP 6
Remove the two screws and remove
the dial plate and selector knob
assembly.
Slide the burr auger rotor/spring
assembly off the motor shaft and
disassemble for cleaning.
CLEANING
STEP 9
Align the slot in the motor shaft with
the rotor and reinstall shear plate.
Reinstall rotor cup and grind selec-
tor dial plate to the burr housing.
Refer to the Operating and Service
manual for burr adjustments.
STEP 8
Carefully clean the grind chamber,
dial plate assembly, chute open-
ing and dial plate opening with a
dry stiff non metallic bristle brush.
Wipe with a clean cloth that has
been soaking in a mild solution of
detergent and hot water. Reinstall
the spring and rotor with burr onto
the motor shaft.
STEP 7
Wash all parts in a mild solution of
detergent with hot water and a stiff
non metallic bristle brush. Rinse all
parts thoroughly and allow them to
air dry before reinstalling.
Komentarze do niniejszej Instrukcji