Bunn H5M Instrukcja Obsługi

Przeglądaj online lub pobierz Instrukcja Obsługi dla Dozowniki wody Bunn H5M. Bunn H5M Service manual Instrukcja obsługi

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
Przeglądanie stron 0
H5M
OPERATING & SERVICE MANUAL
BUNN-O-MATIC CORPORATION
POST OFFICE BOX 3227
SPRINGFIELD, ILLINOIS 62708-3227
PHONE: (217) 529-6601 FAX: (217) 529-6644
To ensure you have the latest revision of the Operating Manual, or to view the Illustrated Parts
Catalog, Programming Manual, or Service Manual, please visit the Bunn-O-Matic website, at
www.bunn.com. This is absolutely FREE, and the quickest way to obtain the latest catalog and
manual updates. For Technical Service, contact Bunn-O-Matic Corporation at 1-800-286-6070.
10267.0000G 04/09 ©1988 Bunn-O-Matic Corporation
Przeglądanie stron 0
1 2 3 4 5 6 ... 19 20

Podsumowanie treści

Strona 1 - BUNN-O-MATIC CORPORATION

H5MOPERATING & SERVICE MANUALBUNN-O-MATIC CORPORATIONPOST OFFICE BOX 3227SPRINGFIELD, ILLINOIS 62708-3227PHONE: (217) 529-6601 FAX: (217) 529-6

Strona 2 - 10267 012609

10SERVICE (cont.)Limit ThermostatLocation:The limit thermostat is located on the tank lid.To test the limit thermostat, access will also be needed to

Strona 3 - USER NOTICES

11SERVICE (cont.)Safety Overflow SwitchLocation:The safety overflow switch is located inside the rear of the dispenser inside the copper overflow cup.Tes

Strona 4 - CE REQUIREMENTS

12SERVICE (cont.)Solenoid ValveLocation:The solenoid valve is located inside the rear of the dispenser on the right side near the bottom.6.

Strona 5 - SUPPORT FOR LARGE RECEPTACLES

13SERVICE (cont.)Tank HeaterLocation:The tank heater is located in the tank lid.Test Procedure:1. Disconnect the dispenser from the power source.2.

Strona 6 - TROUBLESHOOTING

14FIG. 10 THERMOSTAT WIRINGBLU/BLK to Limit ThermostatBLK to Terminal BlockP1782SERVICE (cont.)ThermostatLocation: The mechanical thermostat is locate

Strona 7

15SERVICE (cont.)Liquid Level BoardLocation:The liquid level board is located inside the lower panel.Test Procedure:1. Disconnect the dispenser fr

Strona 8

1615. Move the probe’s flat end to the dispenser housing. The indication must be 0.16. Move the probe’s flat end away from the dis-penser housing. Th

Strona 9

17Location: The contactor is located on the component bracket inside the lower rear panel.Test Procedures:1. Disconnect the dispenser from the

Strona 10 - 10267 071900

18BLK to left Tank HeaterRED to Terminal Block(L2)BLK to TerminalBlock (L1)RED to Right Tank HeaterBLK to LimitThermostatRED from Main HarnessP1725FIG

Strona 11 - Liquid Level Board #2

194312LIQUIDLEVELBOARDBLU/BLKTANK HEATER120 VOLTS A C2 WIRE + GNDSINGLE PHASE10243.0000E 01/07 © 1987 BUNN-O-MATIC CORPORATIONSCHEMATIC WIRING DI

Strona 12 - WHI or RED to Terminal Block

210267 012609BUNN-O-MATIC COMMERCIAL PRODUCT WARRANTYBunn-O-Matic Corp. (“BUNN”) warrants equipment manufactured by it as follows:1) All equipment oth

Strona 13 - 10267 011599

20WIRING DIAGRAMS4312LIQUIDLEVELBOARDBLKSW&THERMOSTAT10262.0001B 04/09 © 1999 BUNN-O-MATIC CORPORATIONSCHEMATIC WIRING DIAGRAM H5MA, 230V CEL1

Strona 14 - BLU/BLK to Limit Thermostat

3CONTENTS Warranty ...2 Introduction ...3 User N

Strona 15

4ELECTRICAL REQUIREMENTSCAUTION - The dispenser must be disconnected from the power source until specified in Initial Set-Up.The H5M dispenser requires

Strona 16 - PNK to Level Probe (T-4)

5INITIAL SET-UPCAUTION - The dispenser must be disconnected from the power source throughout the initial set-up, except when specified in the instructi

Strona 17

6TROUBLESHOOTINGA troubleshooting guide is provided to suggest probable causes and remedies for the most likely problems encountered. If the problem

Strona 18

7TROUBLESHOOTING (cont.)Problem Probable Cause Remedy Automatic refill will not oper-ateafter drawing hot water.Water flows into the tank con-tinu

Strona 19 - 10267 101507

8TROUBLESHOOTING (cont.)Problem Probable Cause Remedy Water boils continuously.Dispenser is making unusual noises.Ready indicator will not li

Strona 20 - SINGLE PHASE

9SERVICEThis section provides procedures for testing and replacing various major components used in this dispenser should service become nec

Komentarze do niniejszej Instrukcji

Brak uwag